Xirrus XR Series

Wireless Access Point
452 The Command Line Interface
auth
The auth command [MyAP(config)# auth] is used to configure Oauth tokens.
See also, “OAuth 2.0 Management” on page 264.
cdp
The cdp command [MyAP(config)# cdp] is used to configure the Cisco Discovery
Protocol.
Command Description
del Delete an Oauth token.
FORMAT:
auth del <Oauth token>
reset Delete all Oauth tokens.
FORMAT:
auth reset
Command Description
disable Disable the Cisco Discovery Protocol
FORMAT:
cdp disable
enable Enable the Cisco Discovery Protocol
FORMAT:
cdp enable
hold-time Select CDP message hold time before messages
received from neighbors expire.
FORMAT:
cdp hold-time [# seconds]