ABB AC500 V3 - Page 22

LED State Color LED = ON LED = OFF LED flashing
Slow flashing (1
Hz):
The firmware
update from the
memory card has
been completed
successfully
or
Boot project is
being updated.
Slow flashing
(0.5 Hz) together
with
MOD1 LED ON:
Mode1: Boot
project is not
loaded.
Two LEDs below
“ERR” and
“MOD1”
Configurable Yellow Configurable Configurable Additional two
LEDs are
reserved and can
be controlled
from IEC user
code with FB
PmLedSet
The AC500-eCo V3 processor module also provides 2 LEDs below the state LEDs which can be
used by user and driven by an application.
The LEDs can be used into a project and controlled using special function blocks which are
contained in the PM AC500 library. The POU is PmLedSet located in folder LED control.
The processor module provides up to 10 LEDs (PM5012-x-ETH), 20 LEDs (PM5032-R-ETH,
PM5052-R-ETH), or 22 LEDs (PM5032-T-ETH, PM5052-T-ETH, PM5072-T-2ETH) to display
the states of the inputs and outputs.
Processor
module
LED State Color LED = ON LED = OFF
PM5012-x-ETH I0..I5 Digital input Yellow Input is ON Input is OFF
O0..O3 Transistor
output
Yellow Output is ON Output is OFF
NO0..NO3 Relay output Yellow Output is ON Output is OFF
PM5032-x-ETH
PM5052-x-ETH
I0..I11 Digital input Yellow Input is ON Input is OFF
O0..O7 Transistor
output
Yellow Output is ON Output is OFF
NO0..NO5 Relay output Yellow Output is ON Output is OFF
C12, C13 Digital configu-
rable input/
output
Yellow Input/Output
is ON
Input/Output is
OFF
PM5072-T-2ETH I0..I11 Digital input Yellow Input is ON Input is OFF
User configu-
rable LEDs
I/O LEDs
Device specifications
Processor modules > AC500-eCo
2022/01/313ADR010278, 3, en_US22