ABB AC500 V3 - Page 55

The module itself does not store configuration data. It receives its parameterization data from
the CPU module during power-up of the system.
Hence, replacing optional modules is possible without any re-parameterization via software.
The arrangement of the parameter data is performed with Automation Builder software.
1. In the device tree, double-click the desired option board.
2. Select the “TA51xx Parameters” tab to edit the parameterization of the desired option
board.
1. In the device tree, double-click the desired option board.
2. Select the “Diagnosis” tab to view the diagnosis messages of the desired option board.
Table 24: Diagnosis messages
Device Severity Error
code
Description
Error Message Remedy
TA5101-4DI 11 1 Wrong or no board
plugged
Replace with correct func-
tional board
TA5101-4DI 11 2 Board defective Replace with correct func-
tional board
TA5101-4DI 11 3 Failed to set direction Replace with correct func-
tional board
TA5101-4DI 11 4 Parameter wrong Verify setting of parameter
“Run on config fault”
LED State Color LED = OFF LED = ON
Inputs I0...I3 Digital input Yellow Input is OFF Input is ON
I/O configura-
tion
Parameteriza-
tion
Diagnosis
State LEDs
Device specifications
Processor modules > AC500-eCo
2022/01/31 3ADR010278, 3, en_US 55