DISPlay Subsystem 5
N1911A/1912A P-Series Power Meters Programming Guide 219
DISPlay:ENABle <boolean>
This command is used to enable and disable the display. At power- up the
display is always enabled.
Syntax
Example
Reset Condition
On reset, the display is enabled.
Query
DISPlay:ENABle?
The query returns a 1 or 0 into the output buffer.
• 1 is returned when the display is enabled
• 0 is returned when the display is disabled
DISP:ENAB 0 This command disables the display.
To Next Page
Loading...
