1 Power Meter Remote Operation
8 N1911A/1912A P-Series Power Meters Programming Guide
• Hostname - SYSTem:COMMunicate:LAN:HNAMe
• Restart Network - SYSTem:COMMunicate:LAN:RESTart
The character_data values for the IP address, Subnet Mask, and Default
Gateway can range between 0.0.0.0 and 255.255.255.255.
The LAN setting values are stored in non- volatile memory and are not
part of the save- recall function.
USB Configuration
The USB interface requires no front panel or remote configuration.
The USB address cannot be changed - it is set at the factory and is
unique for each power meter.
If you configure an invalid IP Address or an IP address that is used by another device or
host, an error message is generated. This error can be read by using the SYSTem:ERRor?
command.
For further information about the USB configuration refer to the P-Series Power Meters
Installation Guide.
Before connecting the USB cable, make sure that I/O software is installed on your
computer.
For more information about Agilent IO Libraries software refer to the Connectivity Guide.
If you have installed other I/O Software, refer to documentation that accompanies the
software
.
To Next Page
Loading...
Need help?
General
