TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 647
INITiate Commands
Initiate commands allow you to place the power meter in the wait for
trigger state.
The INITiate commands are overlapped, that is, the power meter can
continue parsing and executing subsequent commands while initiated. Note
that the pending operation flag is set, when the power meter enters an
idle state and the flag is cleared when it re- enters the idle state.
The following commands are described in this section:
INITiate[1]|2:CONTinuous <boolean>
INITiate[1]|2[:IMMediate]
INITiate:CONTinuous:ALL <boolean>
INITiate:CONTinuous:SEQuence[1]|2 <boolean>
INITiate[:IMMediate]:ALL
INITiate[:IMMediate]:SEQuence[1]|2
To Next Page
Loading...
