MEMory Subsystem 7
N1911A/1912A P-Series Power Meters Programming Guide 265
MEMory:CLEar Commands
These commands are used to remove the contents stored in the sensor
calibration tables (8480 Series sensors and N8480 Series sensors with
Option CFT only), frequency dependent offset tables and save/recall
registers. This subsystem removes the data contents but does not affect
the name of the associated table or save/recall register.
The following commands are detailed in this section:
MEMory:CLEar:[NAME] <character_data>
MEMory:CLEar:TABLe
The contents cleared using these commands are non-recoverable.
To Next Page
Loading...
