EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3CALCulate Subsystem
178 N1911A/1912A P-Series Power Meters Programming Guide
CALCulate[1]|2|3|4:LIMit:FCOunt?
This query returns the total number of limit failures for the specified
window/measurement.
If the appropriate STATe commands are set to ON, each time a
measurement is initiated on the specified window/measurement and the
result is outside the limits, the counter is incremented by one.
If the measured value is equal to a limit, this is a limit pass.
The counter is reset to zero by any of the following commands:
*RST
CALCulate[1]|2|3|4:LIMit:CLEar:IMMediate
CALCulate[1]|2|3|4:LIMit:CLEar:AUTO ON
When CALCulate[1]|2|3|4:LIMit:CLEar:AUTO is set to ON, the counter
is set to zero each time a measurement is:
measured using MEASure?
•read using READ?
initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON
When CALCulate[1]|2|3|4:LIMit:CLEar:AUTO is set to ONCE, the
counter is set to zero the first time a measurement is:
measured using MEASure?
•read using READ?
initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON
The maximum number of errors is 2
16
–1. If more than 2
16
–1 errors are
detected the counter returns to zero.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals