Power Meter Remote Operation 1
N1911A/1912A P-Series Power Meters Programming Guide 29
Editing Frequency Dependent Offset Tables
It is not possible to create any additional frequency dependent offset
tables. However, the 10 existing tables can be edited using the MEMory
subsystem. To do this:
1 Select one of the existing tables using:
MEMory:TABle:SELect <string>
For information on naming frequency dependent offset tables see
“Naming Frequency Dependent Offset Tables” on page 31. For
information on the current names which you can select refer to “Listing
the Frequency Dependent Offset Table Names” on page 30.
2 Enter the frequency data using:
MEMory:TABle:FREQuency <numeric_value> {,<numeric_value>}
3 Enter the offset factors as shown in the table below using:
MEMory:TABle:GAIN <numeric_value> {,<numeric_value>}
4 If required, rename the frequency dependent offset table using:
MEMory:TABLe:MOVE <string>,<string>. The first <string> parameter
identifies the existing table name, and the second identifies the new
table name.
Frequency Offset
Frequency 1 Offset 1
Frequency 2 Offset 2
""
Frequency n Offset n
To Next Page
Loading...
