EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 SENSe Subsystem
444 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:TRACe Commands
These commands are used to set:
The upper and lower limits for the trace display
The delay between the delayed trigger point and the start of the trace
The duration of the trace
The trace units.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:TRACe:LIMit:LOWer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:LIMit:UPPer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:OFFSet:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data>
NOTE
These commands can only be used with P-Series and E9320 sensors. The E9320 sensor
must be set to NORMal mode.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals