13 TRACe Subsystem
628 N1911A/1912A P-Series Power Meters Programming Guide
TRACe[1]|2:MEASurement:TRANsition[1]|...|10:NEGative:DUR
ation?
This command returns the n
th
negative transition duration found on a
trace.
Syntax
Reset Condition
On reset, this parameter is not affected.
Example
Error Messages
• If a P- Series sensor is not connected, error –241, “Hardware missing”
occurs.
• If a P- Series sensor is connected and Free Run trigger acquisition is
selected, error –221, “Settings conflict” occurs.
TRAC
:MEAS
1
2
:TRAN
:NEG
:DUR
?
1
2|...|10
TRAC:MEAS:TRAN8:NEG:DUR? This command returns the 8th negative
transition duration found on trace 1.
To Next Page
Loading...
