EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVice Subsystem 15
N1911A/1912A P-Series Power Meters Programming Guide 717
SERVice:SENSor[1]|2:FREQuency:MINimum?
This query returns the minimum frequency that can be measured by the
currently connected sensor. It is applicable to E- Series sensors only.
Minimum frequency information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
If no sensor is connected, error –241, “Hardware missing” occurs.
If a a sensor other than an E- Series sensor is connected, error –241
“Hardware missing” occurs.
If the E- Series sensor currently connected does not contain the
necessary information in EEPROM, error –241 “Hardware missing”
occurs.
SERV:SENS1:FREQ:MIN? This query returns the minimum
frequency that can be measured by the
E- Series sensor currently connected to
Channel A.
:FREQ
?
:MIN
SERV
1
2
:SENS

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals