DISPlay Subsystem 5
N1911A/1912A P-Series Power Meters Programming Guide 247
DISPlay[:WINDow[1]|2]:TRACe:FEED <character_data>
This command selects which channel’s trace is displayed in the specified
window.
Syntax
Parameters
Example
Reset Condition
On reset, the value is set to:
•Upper window: SENS1
Item Description/Default Range of Values
character_data Identifies which channel’s trace is
displayed.
• SENS1: Channel A
• SENS2: Channel B
“SENS1”
“SENS2”
DISP:WIND2:TRAC:FEED
“SENS1”
This command selects Channel A’s trace to
be displayed in the lower window.
:WIND
1
2
:TRAC
Space
character_data
DISP
:FEED
To Next Page
Loading...
