Agilent Technologies N1911A

15 SERVice Subsystem
716 N1911A/1912A P-Series Power Meters Programming Guide
SERVice:SENSor[1]|2:FREQuency:MAXimum?
This query returns the maximum frequency that can be measured by the
currently connected sensor. It is applicable to E- Series sensors only.
Maximum frequency information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
• If no sensor is connected, error –241, “Hardware missing” occurs.
• If a a sensor other than an E- Series sensors is connected, error –241
“Hardware missing” occurs.
• If the E- Series sensor sensor, currently connected, does not contain the
necessary information in EEPROM, error –241 “Hardware missing”
occurs.
SERV:SENS2:FREQ:MAX? This query returns the maximum
frequency that can be measured by the
E- Series sensor currently connected to
Channel B.
SERV
1
2
:FREQ
?
:SENS
:MAX