7MEMory Subsystem
256 N1911A/1912A P-Series Power Meters Programming Guide
MEMory Subsystem
The MEMory command subsystem is used to:
• Edit and review sensor calibration tables (8480 Series sensors and
N8480 Series sensors with Option CFT only)
• Store sensor calibration tables (8480 Series sensors and N8480 Series
sensors with Option CFT only)
• Edit and review sensor frequency dependent offset tables
• Store sensor frequency dependent offset tables
• Edit and review sensor save/recall registers
Stored tables remain in the power meter’s memory during power down.
The power meter is capable of storing 20 sensor calibration tables and 10
frequency dependent offset tables of 80 frequency points each.
The MEMory subsystem is not used for E-Series, N8480 Series (excluding Option CFT) and
P-Series power sensors calibration tables. These are automatically downloaded to the
power meter and cannot be reviewed or edited.
Keyword Parameter Form Notes Page
MEMory
:CATalog
[:ALL]? [query only] page 259
:STATe? [query only] page 261
:TABLe? [query only] page 262
:CLEar
[:NAME] <character_data> [no query],
[non-SCPI]
page 266
:TABLe [no query] page 268
:FREE
[:ALL]? [query only] page 270
:STATe? [query only] page 271
:TABLe? [query only] page 272
To Next Page
Loading...
Need help?
General
