12 SYSTem Subsystem
498 N1911A/1912A P-Series Power Meters Programming Guide
SYSTem:COMMunicate:LAN:CURRent:DGATeway?
This command returns the current setting of the LAN IP router/gateway
address in use by the power meter.
Syntax
Example
If DHCP or AutoIP are enabled and successful, then one of these IP address modes assigns
the LAN IP router/gateway address, otherwise it is the static LAN IP router/gateway
address
SYST:COMM:LAN:CURR:DGAT? This command queries the current setting
of the LAN IP router/gateway address.
To Next Page
Loading...
