14 TRIGger Subsystem
682 N1911A/1912A P-Series Power Meters Programming Guide
TRIGger[:SEQuence[1]|2]:IMMediate
This command provides a one time over- ride of the normal process of the
downward path through the wait for trigger state. It causes the immediate
exit of the event detection layer if the trigger system is in this layer when
the command is received. In other words, the instrument stops waiting for
a trigger and takes a measurement ignoring any delay set by TRIG:DELay.
Syntax
Example
TRIG:SEQ:IMM This command initiates a measurement
on Channel A.
To Next Page
Loading...
Need help?
General
