17 IEEE 488.2 Command Reference
738 N1911A/1912A P-Series Power Meters Programming Guide
SCPI Compliance Information
This chapter contains information about the SCPI Common (*) Commands
that the power meter supports. It also describes the GPIB Universal
Command statements which form the nucleus of GPIB programming; they
are understood by all instruments in the network. When combined with
programming language codes, they provide all management and data
communication instructions for the system.
The IEEE- 488.2 Common Command descriptions are listed below in
alphabetical order.
*CLS Clear Status page 739
*DDT and *DDT? Define Device Trigger page 740
*ESE and *ESE? Event Status Enable page 742
*ESR? Event Status Register page 744
*IDN? Identify page 745
*OPC and *OPC? Operation Complete page 746
*OPT? Options page 747
*RCL Recall page 748
*RST Reset page 749
*SAV Save page 750
*SRE and *SRE? Service Request Enable page 751
*STB? Status Byte page 753
*TRG Trigger page 755
*TST? Te s t page 756
*WAI Wait page 757
To Next Page
Loading...
Need help?
General
