3CALCulate Subsystem
194 N1911A/1912A P-Series Power Meters Programming Guide
CALCulate[1]|2|3|4:RELative Commands
These commands compare the measurement signal to a reference value.
Within the CALCulate block the relative value is applied to the
measurement signal after any math calculations and display offsets have
been applied.
The commands described in this section:
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO <boolean>|ONCE
CALCulate[1]|2|3|4:RELative:STATe <boolean>
To Next Page
Loading...
