10 SENSe Subsystem
362 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:AVERage Commands
These commands control the measurement averaging which is used to
improve measurement accuracy. They combine successive measurements to
produce a new composite result.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:AVERage:COUNt <numeric_value>
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
[SENSe[1]]|SENSe2:AVERage:SDETect <boolean>
[SENSe[1]]|SENSe2:AVERage[:STATe] <boolean>
To Next Page
Loading...
