EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 349
PSTatistic[1]|2:CCDF:TRACe:MARKer[1]|2[:SET]
This command is used to set the marker on Channel A or Channel B
trace. The markers will be set only if the trace is present and visible.
According to the selections made, the markers will become active on the
screen.
Syntax
Example
Reset Condition
On reset, the marker will be set on the next visible trace according to the
sequence Channel A, Channel B, Reference or Gaussian.
NOTE
This command is only applicable when P-Series sensors are present and the following
conditions are met:
Free-run acquisition mode is selected
NORMal or DOUBle measurement speed setting is chosen
Expanded window is enabled (not full CCDF screen window)
:MARK
:CCDF
:TRAC
2
:SET
1
PST
2
1
PST:CCDF:TRAC:MARK This command sets the marker1 on
Channel A.
PST2:CCDF:TRAC:MARK2 This command sets the marker2 on
Channel B.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals