EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DISPlay Subsystem 5
N1911A/1912A P-Series Power Meters Programming Guide 243
DISPlay[:WINDow[1]|2]:SELect[1]|2
This command is used to select a specific measurement within a specific
window.
If the second numeric value is not sent, the upper measurement of the
relevant window is selected. This command is used to specify which
measurement is used for the analog, trace, or single numeric display.
Syntax
Example
Reset Condition
On reset, the upper window upper measurement is selected.
Query
DISPlay[:WINDow[1]|2]:SELect[1]|2?
The query enters a 1 or 0 into the output buffer indicating whether the
window specified is currently selected.
DISP:WIND2:SEL1 This command selects the upper
measurement in the lower window.
:SEL 1
2
?
:WIND
1
2
DISP

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals