Agilent Technologies N1911A Programming Guide

TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 661
TRIGger[1]|2[:IMMediate]
This command causes a trigger to occur immediately, provided the
specified channel is in the wait for trigger state. When this command is
executed, the measurement result is stored in the power meter’s memory.
Use FETCh? to place the measurement result in the output buffer.
TRIGger[1]|2:DELay:AUTO is ignored if TRIGger[1]|2[:IMMediate] is
set to ON.
Syntax
Example
Error Messages
If the power meter is not in the wait for trigger state, then
TRIGger:IMMediate causes error –211, “Trigger ignored”.
NOTE
This command performs the same function as INITiate[1]|2:[IMMediate].
TRIG This command causes a Channel A trigger
to occur immediately.
TRIG
:IMM
1
2

Agilent Technologies N1911A Specifications

General

Brand	Agilent Technologies
Model	N1911A
Category	Measuring Instruments
Language	English