PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 347
PSTatistic[1]|2:CCDF:TRACe[:STATe] <boolean>
This command is used to turn on or off Channel A or Channel B trace.
Syntax
Example
Reset Condition
On reset, the trace of the physically connected channel will be shown.
This command is only applicable when P-Series sensors are present and the following
conditions are met:
• Free-run acquisition mode is selected
• NORMal or DOUBle measurement speed setting is chosen
• Expanded window is enabled (not full CCDF screen window)
0|OFF
1|ON
Space
?
:STAT
PST
2
1
:CCDF :TRAC
PST:CCDF:TRAC ON This command turns on Channel A trace.
PST2:CCDF:TRAC OFF This command turns off Channel B trace.
To Next Page
Loading...
