STATus Subsystem 11
N1911A/1912A P-Series Power Meters Programming Guide 479
STATus:OPERation:MEASuring[:SUMMary]
The operation status measuring summary register set contains information
on the measuring status of the power meter.
The following bits in these registers are used by the power meter:
These bits are set when the power meter is taking a measurement.
These bits are cleared when the measurement is finished.
Syntax
Bit Number Decimal
Weight
Definition
0 - Not used
1 2 Channel A MEASuring Status
2 4 Channel B MEASuring Status (N1912A only)
3-15 - Not used
To Next Page
Loading...
Need help?
General
