TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 675
TRIGger[:SEQuence]:SLOPe <character_data>
This command specifies whether a trigger event is recognized on the rising
or falling edge of a signal.
Syntax
Parameters
This command is also applicable for external triggered average measurement when used
with 8480, N8480, E4410, E9300 or E9320 sensor (Average mode only).
Item Description/Default Range of Values
character_data How a trigger event is recognized:
• POSitive: a trigger event is recognized on
the rising edge of a signal.
• NEGative: a trigger event is recognized on
the falling edge of a signal.
POSitive
NEGative
:SLOP
Space
?
character_data
TRIG
:SEQ
To Next Page
Loading...
