EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 667
TRIGger[:SEQuence]:HOLDoff <numeric_value>
This command sets the trigger holdoff in seconds.
Syntax
Parameters
Item Description/Default Range of Values
numeric_value The trigger holdoff in seconds.
DEF: the default value is 1 µs
MIN: 1 µs
MAX: 400 ms
Units are resolved to 1 ns.
1 µs to 0.4 seconds
DEF
MIN
MAX
:HOLD
Space
?
numeric_value
DEF
TRIG
:SEQ
MIN
MAX
NOTE
Trigger holdoff is not applicable when the power meter is set to power sweep mode or
frequency sweep mode.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals