SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 373
[SENSe[1]]|SENSe2:AVERage2 Commands
These commands control video averaging, which is used to improve
measurement accuracy, for the P- Series and E- Series E9320 power sensor.
They combine successive measurements to produce a new composite
result.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>
[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>
If the command is used when a sensor other than a P-Series or E9320 power sensor is
connected, error –241, “Hardware missing” occurs.
If the commands in this section are used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings Conflict” occurs.
To Next Page
Loading...
