10 SENSe Subsystem
372 N1911A/1912A P-Series Power Meters Programming Guide
Query Example
Error Messages
•If [SENSe[1]]|SENSe2:AVERage:STATe is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, “Settings
Conflict” occurs.
•If [SENSe[1]]|SENSe2:AVERage:STATe is set to ON when a N1920 or
E9320 power sensor is connected in AVERage measurement mode and
is in the wait- for- trigger state for external trigger buffering, the error
–221, “Settings Conflict” occurs.
SENS2:AVER? This command queries whether averaging
is on or off for Channel B.
To Next Page
Loading...
