Agilent Technologies N1911A Programming Guide

OUTput Subsystem 8
N1911A/1912A P-Series Power Meters Programming Guide 303
OUTPut:TRIGger[:STATe] <boolean>
This command enables or disables the trigger output signal.
When sensor is in triggered average measurement mode, the trigger output
signal will only be asserted after the measurement has settled.
Syntax
Example
Reset Condition
On reset, the trigger output signal is disabled.
NOTE
This command is also applicable when used with 8480, N8480, E4410, E9300 or E9320
sensor (Average mode only).
OUTP:TRIG:STAT 1 This command enables the trigger output
signal.
OUTP
:STAT
:TRIG 0|OFF
1|ON
Space
?

Agilent Technologies N1911A Specifications

General

Brand	Agilent Technologies
Model	N1911A
Category	Measuring Instruments
Language	English