8 OUTput Subsystem
304 N1911A/1912A P-Series Power Meters Programming Guide
Query
OUTPut:TRIGger[:STATe]?
The query command enters a 1 or 0 into the output buffer indicating
whether or not the trigger output signal is enabled or disabled.
• 1 is returned when the trigger output signal is enabled
• 0 is returned when the trigger output signal is disabled
Query Example
Error Messages
• If 8480, N8480, E4410, E9300 or E9320 sensor is connected and the
trigger source is not set to external, error –221 “Settings conflict”
occurs.
OUTP:TRIG:STAT? This command queries the status of the
trigger output signal.
To Next Page
Loading...
