1 Power Meter Remote Operation
84 N1911A/1912A P-Series Power Meters Programming Guide
Making Measurements on Wireless Communication Standards
The following sections describe typical measurements you may want to
make. They are also described, for front panel operation, in the user’s
guide.
The optimum method of measuring these Wireless Communication
Standards is to use the SYSTem:PRESet <character_data> command and
use one of the following values.
• GSM900 -See “GSM900” on page 533 for greater detail.
• EDGE -See “EDGE” on page 536 for greater detail.
• CDMAone -See “CDMAone” on page 540 for greater detail.
• CDMA2000 -See “CDMA2000” on page 544 for greater detail.
• WCDMA -See “W- CDMA” on page 548 for greater detail.
• BLUetooth -See “BLUetooth” on page 552 for greater detail.
• MCPa -See “MCPA” on page 555 for greater detail.
• RADar -See “RADAR” on page 558 for greater detail.
• WL802DOT11A -See “802.11a and HiperLan2” on page 562 for greater
detail.
• WL802DOT11B -See “892.11b/g” on page 565 for greater detail.
• XEVDO -See “1xeV- DO” on page 568 for greater detail.
• XEVDV -See “1xeV- DV” on page 571 for greater detail.
• TDSCdma -See “TD- SCDMA” on page 574 for greater detail.
• NADC -See “NADC” on page 577 for greater detail.
• IDEN -See “iDEN” on page 581 for greater detail.
• DVB - See “DVB” on page 585 for greater detail.
• HIPERLAN2 -See “802.11a and HiperLan2” on page 562 for greater
detail.
To Next Page
Loading...
Need help?
General
