SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 451
[SENSe[1]]|SENSe2:V2P ATYPe|DTYPe
This command is used to select the type of linearity correction that is
applied to the channel sensors being used. For most 8480 Series sensors,
the correct (A type or D type) linearity correction table is automatically
selected. However, for the V8486A and W8486A sensors, D type (diode)
correction is selected and the automatic selection must be overridden.
Syntax
Example
Reset Condition
On reset, the linearity correction is set for A type.
This command is only applicable for V8486A and W8486A sensors.
SENS2:V2P DTYP This command selects the D type linearity
correction to be applied to Channel B.
SENS
1
SENS2
:
V2P
ATYP
DTYP
Space
?
To Next Page
Loading...
Need help?
General
