9 PSTatistic Subsystem
328 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:REFerence:POWer:PEAK?
This command is used to retrieve the peak power data of the saved
reference trace.
Syntax
Example
Error Messages
• If command is executed in other window besides CCDF window, error
–221 "Settings conflict: Requires CCDF window" occurs.
• If there was no previously saved trace, error –221 "Settings conflict: No
reference trace saved" occurs. Please check the status of saved reference
trace using command PST:CCDF:STOR:REF?.
This command is only applicable when P-Series sensors are present and the following
conditions are met:
• Free-run acquisition mode is selected
• NORMal or DOUBle measurement speed setting is chosen
PST:CCDF:REF:POW:PEAK? This command returns the peak power
value of the saved reference trace.
To Next Page
Loading...
Need help?
General
