14 TRIGger Subsystem
646 N1911A/1912A P-Series Power Meters Programming Guide
ABORt[1]|2]
This command removes the specified channel from the wait for trigger
state and places it in the idle state. It does not affect any other settings of
the trigger system. When the INITiate command is sent, the trigger
system responds as it did before ABORt was executed.
If INITiate:CONTinuous is ON, then after ABORt the specified channel
immediately goes into the wait for trigger state.
Syntax
Example
ABOR This command places Channel A in the
idle state.
To Next Page
Loading...
