Agilent Technologies N1911A Programming Guide

TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 673
TRIGger[:SEQuence]:LEVel:AUTO <boolean>
This command enables/disables automatic setting of the trigger level.
When this command is set to:
• ON, automatic setting of the trigger level is enabled.
• OFF, automatic setting of the trigger level is disabled.
• ONCE, automatic setting of the trigger level is enabled for one trigger
event only. The value is then set to OFF.
Syntax
Example
Reset Condition
On reset the value is set to ON.
TRIG:SEQ:LEV:AUTO 0 This command disables the automatic
setting of the trigger level for Channel A.
:LEV
0|OFF
1|ON
Space
?
:AUTOTRIG
:SEQ
ONCE

Agilent Technologies N1911A Specifications

General

Brand	Agilent Technologies
Model	N1911A
Category	Measuring Instruments
Language	English