15 SERVice Subsystem
710 N1911A/1912A P-Series Power Meters Programming Guide
SERVice:SENSor[1]|2:CALFactor <cal_factor_data>
This command writes calibration factor data to, or reads calibration factor
data from, the currently connected sensor. The whole calibration factor
block must be written at once as a checksum is generated. The new block
must not be larger than the existing block.
This command applies to the following sensors:
• E4410 Series
• N8480 Series (excluding Option CFT)
• E9300 Series
• E9320 Series, average path data
For E9320 Series sensors, peak path, refer to
“SERVice:SENSor[1]|2:PCALfactor <cal_factor_data>” on page 718.
Syntax
Parameters
Item Description/Default
cal_factor_data A binary data block. Refer to Appendix A, “Calibration
Factor Block Layout,” on page A-763 for further
information.
SERV
1
2
:CALF
:SENS
cal_factor_data
?
Space
To Next Page
Loading...
