Power Meter Remote Operation 1
N1911A/1912A P-Series Power Meters Programming Guide 35
Auto Averaging Mode
To enable and disable auto filter mode, use the following command:
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
When the auto filter mode is enabled, the power meter automatically sets
the number of readings averaged together to satisfy the filtering
requirements for most power measurements. The number of readings
averaged together depends on the resolution and the power level currently
being measured. Figure 1- 2 lists the number of readings averaged for each
range and resolution when the power meter is in auto filter mode.
Figure 1-2 Typical Averaged Readings on 8480 Series Sensors
Figure 1- 3 illustrates part of the power sensor dynamic range hysteresis.
Figure 1-2 applies to 8480 Series only.
10 dB
10 dB
Minimum Sensor Power
Maximum Sensor Power
Power Sensor
Dynamic Range
10 dB
10 dB
1234
8 8 128 128
Resolution Setting
Number of Averages
1 1 16 256
11232
11116
1118
To Next Page
Loading...
Need help?
General
