EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 PSTatistic Subsystem
330 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic[1]|2:CCDF:CONTinuous <boolean>
This command is used to turn on or off the CCDF Continuous Refresh
mode for Channel A or Channel B.
Syntax
Example
Reset Condition
On reset, the CCDF Continuous Refresh mode will be turned on.
NOTE
This command is only applicable when P-Series sensor is present and free-run acquisition
mode is selected. If P-Series sensor is used by the adjacent channel in a dual channel
setup, the same setting will be applied for free-run acquisition mode.
PST
2
:CCDF
:CONT
1
0|OFF
1|ON
Space
?
PST1:CCDF:CONT ON This command turns on the CCDF
Continuous Refresh mode for Channel A.
PST2:CCDF:CONT OFF This command turns off the CCDF
Continuous Refresh mode for Channel B
and the Single Refresh mode is on.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals