PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 331
Query
PStatistic[1]|2:CCDF CONTinuous?
The query enters 1 or 0 into the output buffer indicating the status of the
CCDF Continuous Refresh mode.
• 1 is returned when the CCDF Continuous Refresh mode is enabled
• 0 is returned when the CCDF Continuous Refresh mode is disabled (or
CCDF Single Refresh mode is enabled)
Query Example
Error Messages
• If no sensor or wrong sensor is connected to the channel, error –241
"Hardware missing" occurs.
• If channel is not in free- run acquisition mode, error –221 "Settings
conflict" occurs.
PST1:CCDF:CONT? This command queries whether the CCDF
Continuous Refresh mode is on or off for
Channel A.
To Next Page
Loading...
