EasyManua.ls Logo

Agilent Technologies N1911A

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 665
TRIGger[:SEQuence]:DELay <numeric_value>
This command sets the delay between the recognition of a trigger event
and the start of a measurement.
Syntax
Parameters
Item Description/Default Range of Values
numeric_value The delay between the recognition of a
trigger event and the start of the
measurement.
DEF: the default value is 0 seconds
Units are resolved to 1.25 ns.
–1 to 1 second
DEF
:DEL
Space
?
numeric_value
DEF
TRIG
:SEQ
NOTE
Trigger delay is not applicable when the power meter is set to power sweep mode or
frequency sweep mode.

Table of Contents

Other manuals for Agilent Technologies N1911A

Related product manuals