SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 391
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
These commands are used to select the active sensor calibration table
(using CSET1) and the active frequency dependent offset table (using
CSET2).
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe <boolean>
If any of the CSET1 commands are used when a P-Series, N8480 Series (excluding Option
CFT) or E-Series power sensor is connected, the error –241, “Hardware missing” occurs.
To Next Page
Loading...
Need help?
General
