TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 669
TRIGger[:SEQuence]:HYSTeresis <numeric_value>
This command sets:
• How far a signal must fall below TRIG:LEVel before a rising edge can
be detected.
• How far a signal must rise above TRIG:LEVel before a falling edge can
be detected.
Syntax
Parameters
Item Description/Default Range of Values
numeric_value How far a signal must fall/rise before a
rising or falling edge can be detected.
• DEF: the default value is 0 dB
Units are resolved to 0.05 dB.
0 to 3 dB
DEF
:HYST
Space
numeric_value
?
DEF
TRIG
:SEQ
To Next Page
Loading...
Need help?
General
