Agilent Technologies N1911A

CALCulate Subsystem 3
N1911A/1912A P-Series Power Meters Programming Guide 173
CALCulate[1]|2|3|4:LIMit Commands
These commands set the limits on both the upper and lower
windows/measurements enabling you to:
• Set upper and lower level limits
• Query if there has been a failure
• Count the number of failures
• Clear the counter
The following commands are detailed in this section:
CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>
CALCulate[1]|2|3|4:LIMit:CLEar[IMMediate]
CALCulate[1]|2|3|4:LIMit:FAIL?
CALCulate[1]|2|3|4:LIMit:FCOunt?
CALCulate[1]|2|3|4:LIMit:LOWer[:DATA]
CALCulate[1]|2|3|4:LIMit:UPPer[:DATA]
CALCulate[1]|2|3|4:LIMit:STATe <boolean>