13 TRACe Subsystem
632 N1911A/1912A P-Series Power Meters Programming Guide
TRACe[1]|2:MEASurement:TRANsition[1]|...|10:POSitive:DURa
tion?
This command returns the n
th
positive transition duration found on a
trace.
Syntax
Reset Condition
On reset, this parameter is not affected.
Example
Error Messages
• If a P- Series sensor is not connected, error –241, “Hardware missing”
occurs.
• If a P- Series sensor is connected and Free Run trigger acquisition is
selected, error –221, “Settings conflict” occurs.
TRAC
:MEAS
1
2
:TRAN
:POS
:DUR
?
1
2|...|10
TRAC:MEAS:TRAN10:POS:DUR? This command returns the 10th positive
transition duration found on trace 1.
To Next Page
Loading...
Need help?
General
