SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 381
[SENSe[1]]|SENSe2:BUFFer:COUNt <numeric_value>
This command sets the buffer size for average or peak measurement. It
must be used in conjunction with external trigger.
It can only be set when frequency sweep is disabled (FREQ:STEP 0).
Otherwise, this parameter will be automatically overwritten by frequency
sweep step. If trace display is turned on, the measurement window will be
restored to single numeric or analog depends on the number of
measurement channel.
Syntax
Parameters
This command is only applicable when used with 8480, N8480, E4410, E9300, E9320 or
N1920 power sensors (average or peak).
Item Description Range of Values
numeric_value A numeric value for buffer size. 1 to 2048
:COUN
Space
?
numeric_value
SENS
1
SENS2
FREQ
:
To Next Page
Loading...
Need help?
General
