Agilent Technologies N1911A Programming Guide

SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 401
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe
<boolean>
This command is used to enable and disable the pulse power measurement
feature.
The [SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 command should be
used to enter the duty cycle of the signal you want to measure.
Syntax
Example
Reset Condition
On reset, the pulse power measurement feature is disabled.
Query
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the pulse power measurement feature.
CORR:DCYC:STAT 1 This command enables the pulse
measurement feature on Channel A.
SENS
1
:DCYC
CORR
SENS2
:
:STAT
0|OFF
1|ON
Space
?
:GAIN3

Agilent Technologies N1911A Specifications

General

Brand	Agilent Technologies
Model	N1911A
Category	Measuring Instruments
Language	English