14 TRIGger Subsystem
676 N1911A/1912A P-Series Power Meters Programming Guide
Example
Reset Condition
On reset the value is set to POSitive.
Query
TRIGger[:SEQuence]:SLOPe?
The query returns the current value of <character_data>.
Query Example
Error Messages
• If 8480, N8480, E4410, E9300 or E9320 sensor is connected and trigger
source is not set to external, –221 “Settings conflict” occurs.
TRIG:SEQ:SLOP NEG This command sets the trigger event to be
recognized on the falling edge of the
triggering signal.
TRIG:SEQ:SLOP? This command queries the current value
of <character_data> for Channel A.
To Next Page
Loading...
