Agilent Technologies N1911A

10 SENSe Subsystem
358 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed] <numeric_value> 412
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STARt
<numeric_value> 415
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXEd]:STEP
<numeric_value> 418
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STOP
<numeric_value> 422
[SENSe[1]]|SENSe2:MRATe <character_data> 425
[SENSe[1]]|SENSe2:POWer:AC:RANGe <numeric_value> 428
[SENSe[1]]|SENSe2:POWer:AC:RANGe:AUTO <boolean> 430
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4 Commands 432
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:AUTO <character_data> 433
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:AUTO:REF1|REF2
<numeric_value> 436
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:OFFSet:TIME
<numeric_value> 438
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:TIME <numeric_value> 440
[SENSe[1]]|SENSe2:TEMPerature? 442
[SENSe[1]]|SENSe2:TRACe Commands 444
[SENSe[1]]|SENSe2:TRACe:OFFSet:TIME <numeric_value> 445
[SENSe[1]]|SENSe2:TRACe:TIME <numeric_value> 447
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data> 449
[SENSe[1]]|SENSe2:V2P ATYPe|DTYPe 451
SENSe[1]|2:TRACe:AUToscale 453
SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value> 455
SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value> 458
SENSe[1]|2:TRACe:X:SCALe:PDIV <numeric_value> 461
SENSe[1]|2:TRACe:Y:SCALe:PDIV <numeric_value> 463
This chapter explains how the SENSe command subsystem directly affects
device specific settings used to make measurements.