4
1. Please read all notes related to installation and wiring in the manual.
If this is not observed, electrical shock or malfunction may occur.
2. Make sure the ground wire of Graphic Panel is wired separately from the ground
wires of other devices. Ground resistance must be less than 100Ω, and a lead wire
of which sectional area is over 1.25mm²should be used.
If this is not observed, electrical shock or malfunction may occur.
3. When connecting Graphic Panel ports and constructing input/output, check the
pin number and terminal block before connecting.
It may cause a fire or a malfunction.
4. Please tighten bolt on terminal block with specified tightening torque.
It may cause a short circuit, fire or a malfunction.
5. Do not press the surface of the touch panel with sharp or hard objects.
The touch panel may be damaged.
6. Keep Graphic Panel at the specified temperature.
If stored at a temperature beyond the specification, damage may occur.
7. Do not inflow dust or wire dregs into the unit.
It may cause a fire or a malfunction.
8. Do not use in an area with excessive humidity or temperature.
The Logic Panel may malfunction, or its useful life may be shortened.
9. Do not close ventilating opening of this product.
Malfunction may occur due to temperature increase.
10. Keep the product out of direct sunlight or excessive dust.
The Logic Panel may malfunction, or its useful life may be shortened.
11. Do not use or store in a place with shock or vibration.
The Logic Panel may malfunction, or its useful life may be shortened.
12. When liquid crystal from the broken LCD is smeared with skin, wash it for 15
minutes. If it is gotten in the eye, wash it for 15 minutes and contact with the
medical specialist for more information.
13. In cleaning unit, do not use water or an oil-based detergent and use dry towels.
It may cause an electric shock or a fire.
14. Please separate as an industrial waste when disuse this unit.
Caution
To Next Page
Loading...
Need help?
General